Buffering Scheme Drives Large

Abstract: This applicaTIon notes shows how to buffer the triplex backplane drive outputs of a LCD driver such as MAX7231 family to increase the capaciTIve drive capability. This enables a large LCD to be driven without ghosTIng and other arTIfacts due to backplane waveform distortion.

To conserve pins, many LCD Drivers triplex their drive signals—a technique that enables AC waveforms on trhree common lines and three segment lines to activate any standard character of a seven-segment display. Large LCDs of 1 "or more exhibit a large capacitance between the common and segment electrodes (several nonofarads), which presents a problem for standard LCD drivers.

These drivers' high output impedance (50KΩ, for example) causes difficulty in driving capacitance, and the consequent AC-Waveform distortioncan produce ghosting and shadow segments in the display. The drive circuit in Figure 1 solves this problem by introducing a buffer amplifier for each of the three common lines. Each amplifier may be programmed independently for a quiescent current of 10, 100 or 1000µA. In this application, the bias network applies a voltage that sets the three quiescent currents to 100µA.

The display driver and triple op amp operate between 5V and ground, and the COM signals range from 5V to ~ 1V. To assure that these signals remain within the amplifiers' common-mode range. We attenuate the signalsby one half and operate the buffers at a gain of two. The circuit drives eight 1 "displays and is suitable for ambient temperature variations of 15 ° F or less. At the highest expected temperature, you should adjust R1 so that no" off "segments are visible.


Figure 1. Three buffer amplifiers enable this standard LCD driver (IC1) to control eight large (1 ") seven-segment displays."

SMT PCB Assembly =  SMT Printed Circuit Board Assembly, which means the PCB Board only have SMT parts need be assembled. Zhongfeng would manufacture the rigid PCB boards follow the design file, source the components follow the BOM file and do the PCB Assembly job follow the assembly drawing and the pick&place file. After PCB assembly done, the components would be mounted on the PCB boards tightly and connected each other through the copper circuits. We call such board as PCBA board or SMT PCBA board.

 

Depends on the components assembly types, it have THT PCB assembly, SMT PCB assembly, one sided SMT and THT PCB assembly, two sided SMT and THT PCB assembly.

 

Depends on the PCB type, it have Rigid PCB Assembly, Flex PCB Assembly and Flex-Rigid PCB Assembly.

 

Also we would call some PCB assembly types as Prototype PCB Assembly, Mass PCB Assembly , Turnkey PCB Assembly, LED PCB Assembly and BGA PCB Assembly , etc.

 

With our 15years professional experience, we are available for all types of PCB assembly service from prototype to mass production, available for 01005, 0201, 0.3mm BGA, 0.3mm QFP.

PCB Assembly Capabilities

PCB Assembly Products Show

PCB SMT Assembly Factory Show

SMT PCB Assembly

SMT PCB Assembly,Surface Mount SMT PCB Assembly, Professional SMT PCB Assembly,Electronic SMT PCB Assembly

ZhongFeng Electronic Technology Co., Limited , https://www.dopcba.com